Installation and operating instructions for oven

16
GB
Recommendations for starting the
sauna oven for the first time
It is known that the heating elements absorb residual
moisture due to climate differences, and that this
results in the RCCB tripping without the heating
elements actually suffering a fault. Therefore if the
sauna oven is exposed to large temperature
differences (in the winter) it should be left in a
temperature-controlled room for at least 12 hours.
What to do if the RCCB trips anyway
Have the electrician check the ohm values between
the core and core with an insulation measuring
instrument
15 - 18 액 on the SHG 3.6 kW
19 - 23 액 on the SHG 7.5 kW
33 - 39 액 on the SHG 7.5 kW for evaporator only
16 - 19.5 액 on the SHG 9.0 kW
33 - 39 액 on the SHG 9.0 kW for evaporator only
and between the core and earth (over 1 M액 on all
ovens). If the differences are excessive, return the
oven to the manufacturer.
Heating for approx. 10 minutes without the RCCB
The electrician can heat the sauna oven for approx.
10 minutes using the safety conductor connector.
After 10 minutes the oven will be reconnected
properly to the RCCB. If the RCCB trips anyway,
please return the oven to the manufacturer.
In any event the oven must be connected properly to
the domestic installation system using an RCCB as
set out in VDE 0100.
Installation instructions
앬 For the installation of the sauna oven ensure that
the vertical distance between the top of the
sauna oven and the ceiling of the sauna booth is
at least 110 cm and the horizontal (lateral)
distance between the oven and the wall of the
booth is at least 7 cm. The distance between the
bottom of the oven and the floor depends on the
design of the oven (adjustable feet). However, it
should be ensured that the oven is not placed on
a floor made of highly inflammable material
(wood, plastic flooring, etc.). Ideally ceramic tiles
or the like should be used in the sauna. The
distance between the rear wall of the oven and
the wall of the booth also depends on the design
(wall bracket).
앬 The distance between the oven safety grille or
the bench and other inflammable materials from
the oven must be at least 7 cm. The height of the
safety grille must be equal to the height of the
oven at the front.
min. 110
min. 175
38
min. 7
Anleitung SHG Classic:Anleitung SHG 3,3-9,0KW_93s 11.12.2007 10:33 Uhr Seite 16