G A S - P O W E R E D W AT E R P U M P OWNER’S MANUAL WARNING: Read carefully and understand all INSTRUCTIONS before operating. Failure to follow the safety rules and other basic safety precautions may result in serious personal injury.
Thank you very much for choosing a Wel-Bilt™ product! For future reference, please complete the owner’s record below: Model: _______________ Purchase Date: _______________ Save the receipt, warranty and these instructions. It is important that you read the entire manual to become familiar with this product before you begin using it. This machine is designed for certain applications only. The distributor cannot be responsible for issues arising from modification.
this product, but must be supplied by the operator. SAVE THESE INSTRUCTIONS WORK AREA · Keep work area clean, free of clutter and well lit. Cluttered and dark work areas can cause accidents. · Do not use your water pump where there is a risk of causing a fire or an explosion; e.g. in the presence of flammable liquids, gasses, or dust. Gasoline engines can create sparks, which may ignite the dust or fumes. · Keep children and bystanders away while operating a water pump.
· Dress properly. Do not wear loose clothing, dangling objects, or jewelry. Keep your hair, clothing and gloves away from moving parts. Loose clothes, jewelry or long hair can be caught in moving parts. Air vents often cover moving parts and should be avoided. · Use safety apparel and equipment. Use safety goggles or safety glasses with side shields which comply with current national standards, or when needed, a face shield. Use as dust mask in dusty work conditions.
ASSEMBLY Installation of connective soft pipe: Affix the soft rubber pipe to the connector of inlet pipe. Please note it must be installed over the thread. Tighten it with clipper joint. On the other end of the rubber pipe, a filter should be attached. OPERATION IMPORTANT: • Before starting, remove self-suction plug and pour water in the pump until water overflows. When filled, tighten the plug firmly. • Fully tighten self-suction plug, suction hose and others connections.
turned off. The muffler area will be very hot. Allow to cool before servicing, if needed. Run new or newly maintained machine at low speed with low load during the first 20 hours. Do not run it at high speed with full load. MAINTENANCE WARNING: Make sure this tool is disconnected from its power source before attempting any maintenance, cleaning, or inspection. • Maintain your water pump. It is recommended that the general condition of any tool be examined before it is used.
The flow of water is not enough Power consumption of pump is too great Excessive vibration or noise No flow at all Malfunction Impeller is damaged and leaking Replace with a new impeller. Total head is too high. There is air in the pump or inlet, air leak into the seal. Check the reason, adjust it. Screw off air drain screw cock, and eliminate the air. Check the pipeline or change machinery seal. Speed of engine is not stable. Adjust the speed of engine.
Excessive vibration or noise Malfunction Cause Remedy There is air in the pump or pipeline. Screw off air drain screw cock and expel the air. Impeller damaged. Stop the machine to check and replace with a new impeller.
DIAGRAM & PARTS LIST Page 9 of 12
Part# Description Qty. Part# Description Qty.
Page11of 12
Part# Description Qty. Part# Description Qty. 2-1 1" Pump Housing 1 2-22 Throttle Lever 1 2-2 Washer Ф6.
