Operation Manual

22
Press the MEM button in order to access the
memory mode. Then press the SET button and
keep it pressed for approx. 2 seconds until the
temperature measurement display has switched
from °C (degree Celsius) to °F (degree Fahrenheit
/ 1 acoustic signal) or vice versa from °F (degree
Fahrenheit) to °C (degree Celsius / 2 acoustic
signals).
8.5 Setting °Celsius / °Fahrenheit
By default, the device has been set in such a way
that it switches to the standby mode (time, date
and ambient temperature are shown alternate-
ly) approx. 30 - 60 seconds, depending on the
respective mode, after the last button has been
pressed. If you wish that the device switches off
completely after approx. 1 minute, you can pro-
ceed as follows:
Press the SET button in the standby mode and
keep it pressed for approx. 2 seconds until the
24 hr symbol on the display starts to flash. Then
press the SET button six times until the LCd sym-
bol appears on the display for a short period of
time and the ON symbol flashes immediately
afterwards. If you press the MEM button now, the
OFF symbol starts to flash on the display. After-
wards, press the SET button in order to save this
setting. Now, the device returns to the standby
mode and switches off automatically approx. 1
minute after the last button has been pressed. If
you wish to switch the device back to the perma-
nent standby mode, you can set the LCd / OFF
setting to ON according to the description above.
8.4 Energy saving mode
BASIC FUNCTIONS
D
USA
19.PJN174-14_GA-USA_HHD-Ohrthermometer_DSO364_28.07.14
Montag, 28. Juli 2014 14:37:39