Operation Manual

23
Step 3: On the display, the hour display flashes
now and you can set the value, depending on the
previously selected time mode, from 1 to 12 or
from 1 to 24 by pressing the MEM button and
save the value set by pressing the SET button.
Step 2: By pressing the MEM button, you can
select the required time mode and save it by
pressing the SET button. If the 12-hour display
(12 hr) has been set, the PM symbol appears on
the display for time displays.
Step 1: Press the SET button and keep it pressed
for approx. 2 seconds in order to access the
setting mode. The display for the time mode
(either 12 hr or 24 hr) flashes.
9.2 Setting and time date
In the standby mode and in the memory mode,
the device alternately shows ambient tempera-
ture (°C or °F), time (hours / minutes) in the 24-
hour or 12-hour mode (PM) and date (month /
weekday). The two flashing points between the
hour and minute display signal intervals of one
second.
9.1 Display of time and date
9.0 Display / setting time and
date
TIME AND DATE
USA
19.PJN174-14_GA-USA_HHD-Ohrthermometer_DSO364_28.07.14
Montag, 28. Juli 2014 14:37:39