Operation Manual

Fig. 15

Fig. 16

PLEASE NOTE: Wait until the measurement was

saved and no more circles are shown on the display.

Step 4: Carefully remove the measuring tip of the

thermometer from the external ear canal and read

the temperature measured on the LCD display

(e.g. as shown in Fig. 16). The symbol ( )

indicates that an ear temperature measurement

was carried out. A new measurement can only be

carried out after the backlighting has gone out

(waiting time of approx. 6 seconds).

ture measured is below 99,5 °F (con-

stant green light), if there is elevated tempera-

ture in the range from to 100.3 °F(single

acoustic signal and red flashing light / approx.

every 2 seconds) or if the body temperature is in

the fever range from 100.4 °F to 109.3 °F (two

acoustic signals and red flashing light at intervals

of one second; in addition to this, FE (for fever) is

shown on the display). PLEASE NOTE: The corre-

sponding temperature values in °C (degree

Celsius) can be found in section 8.2 on page 21).

99,5 °F

Step 3: Keep the device still and

then press the ( ) “Ear measure-

ment” button (see Fig. 15). A single

acoustic signal indicates that the

measurement has been started. Aft-

er approx. 2 seconds, two acoustic

signals confirm that the temperature

measurement has been completed.

The ( ) symbol and the ear tem-

perature measured are shown on the

display (e.g. as shown in Fig. 16).

At the same time, the backlighting

lights up and signals if the tempera-

TEMPERATURE MEASUREMENT

USA

19.PJN174-14_GA-USA_HHD-Ohrthermometer_DSO364_28.07.14

Montag, 28. Juli 2014 14:37:39