User Manual

Chapter 4 Settings
4-48
Chap.
4
4-10-3 Barcode Scanning test
Perform a barcode scanning test, as described below. A sample barcode can be
found in "Sample Barcode" (Appendix B-2).
1. From the System Menu, select "6:Test."
2. Then select "3:Barcode."
3. Press the scan key to scan the barcode. The scan
result is displayed on the screen, similar to the
image shown right.
The scanned barcode is displayed on the 2nd line.
The type and the number of digits of the scanned
barcode are displayed on the bottom line. If you hold
down the scan key for approximately 1 second, the continuous scanning
mode will be enabled. Scanning will continue until you release the scan key,
and the success rate will be displayed in the bottom right of the screen.
If the trigger mode or the power save mode is set, it will not affect the
continuous scanning.
4-10-4 Screen Display Test
Perform a screen display test, as described below.
1. From the System Menu, select "6:Test."
2. Then select "4:LCD"
3. The backlight is turned ON and the whole screen is
filled in. If any keys are pressed, the corresponding characters will be
displayed on the screen in sequence. If the scan key is pressed, the test will
stop with the screen displaying where the test stopped. The test will resume
if the scan key is pressed again. If the
key is pressed, the test will be
aborted and the CTR-800-11W will return to the screen immediately before
the test.
< Barcode Test >
4994121104579
JAN13 L:13 100％
、。，．・：；？！
゛゜´｀¨＾￣＿ヽヾ
ゝゞ〃仝々〆〇ー―‐
／＼～∥｜…‥‘’“
”（）〔〕［］｛｝〈
こ
ご
さ
ざ
しじ
すず
せ
ぜ
そぞただちぢっつづて
でとどなにぬねのはば
ぱひびぴふぶぷへべぺ
ほぼぽまみむめもゃや
……
< Test Menu >
1:RF 5:KEY
2:COM
3:Barcode
4:LCD
< Test Menu >
1:RF 5:KEY
2:COM
3:Barcode
4:LCD