User Manual

4-3 Starting the System Menu

4-5

Chap.

4-3 Starting the System Menu

4-3-1 How to Start the System Menu

1. Once the CTR-800-11W has been correctly installed with a battery pack and

if the current state is OFF, press the

key for approximately 1 second. The

power will turn ON and the System Menu will be started.

2. The System Menu is displayed immediately after the

opening screen.

If an application is set for "Startup" (P.4-7), hold down

the scan key and then press the

key to start the

System Menu.

4-3-2 Executing a DHCP Request

If the network DHCP setup (P.4-23) is set as "Run at

startup", a DHCP request is executed immediately after

the CTR-800-11W starts.

If the system is in the state where wireless

communications with an access point is possible and if

the DHCP server and FTP server of the "WebGlider" network management tool

have been started, the various environmental setting values and specified files

will be downloaded to the CTR-800-11W and automatic setup will be performed

via the TCP/IP network.

After the DHCP request has been executed, the applications set for "Automatic

Launch," if any, will start. (P.4-7)

4-3-3 Starting State for Wireless Operation

Immediately after starting, the CTR-800-11W's wireless communication unit is

set to a suspended state. If the wireless communications related menu is

selected immediately after starting, the CTR-800-11W will be ready for

communication within 0.5 to 1 second.

CTR-800-11W

< System Menu >

1:System 4:File

2:Network 5:Status

3:TermID 6:Test

< DHCP Client >

Connect to

DHCP server ..