User Manual

4-5 System Setup Menu
4-15
Chap.
4
4-5-7 Suspend Mode Setup
This section describes how to set up the suspend function.
1. From the System Menu, select "1:System."
2. Then select "7:Suspend."
●Suspend ON
After the CTR-800-11W's power is off, and the next time
the
key is pressed to start it, it will resume
processing from where it was when the power was last
turned off.
The screen shown right will be displayed when the
CTR-800-11W is started with the suspend mode enabled.
(If the
key is pressed while the scan key is being
pressed, the suspend mode will be canceled and the
restart process will be executed from the beginning).
Just before the power is turned OFF with the suspend
mode enabled, the screen shown right is displayed.
(Before removing the battery pack, wait for about 3
seconds after the screen (shown right) has
disappeared).
Please do not remove a battery pack by any means when these screens are dis-
played. If a battery pack is removed at this time, it may become impossible to start.
●Suspend OFF
After the CTR-800-11W's power is OFF, the next time the
key is pressed, it
will begin processing from the beginning.
The resume function is effective when turning OFF/ON the power using the
key. If the battery pack is removed during operation, the restart process will be ex-
ecuted from the beginning regardless of the resume function setup. Even if the
power is OFF and the battery pack is removed, the restart process will be executed
from the beginning when the DHCP settings are set to "Execute at startup."
< System Config >
1:Startup 5:Buzzer
2:COM 6:Scanner
3:Clock 7:Suspend
4:LCD
< Suspend Mode >
1:ON
2:OFF
Resume from
Suspend Mode.
Go into
Suspend Mode.