User Manual

Chapter 4 Settings
4-46
Chap.
4
< Test Menu >
1:RF 5:Key
2:COM
3:Barcode
4:LCD
< RF Test >
1:Parameter
2:Site Survey
3:Ping
4:Serarch AP
< Search AP >
Target SSID =
ANY
Search Access Ponit..
< AP Search Result >
00A0F850D7D3 01
00A0F850D7F4 06
00A0F850D7CE 11
< AP Property >
MAC[00A0F850D7D3]
SSID = 80011
1:Survey 2:Select
1. From the System Menu, select "6:Test."
2. Then select "1:RF."
3. Then select "4:Search AP."
4. A search for access points will be started. The SSID
that has been set through the "■SSID Setup" (P.4-
17) is displayed on the lines 3 and 4 on the screen,
and an access point with the same SSID setup will be
searched. If the value "ANY" (or no character) has
been set, any available access point will be searched
regardless of the SSID.
5. The access point search results are displayed. In the
results shown, the access point MAC addresses and
synchronous channels are listed in descending order
of communication quality. Once an access point is
selected from the search results, the SSID of that
access point can be obtained. A wireless test can be
performed with the access point only.
Press the
key to return to 3.
6. The SSID of the selected access point is displayed
(the SSID in the image shown right is "80011").
Select "1:RF" to initiate a wireless test with the
selected access point only. To perform this test, the
" ■ Conditions Setup" (P.4-43) must have been
completed.
Selecting "2:Select" will set up the SSID with the character string displayed
here.