User's Manual

Chapter4 FAQ
4-4ġ
ѺÉãáîîïôðåòæïòí÷éòåìåóóäáôáãïííõîéãáôéïîó®
ǪÉóôèåáããåóóðïéîôãïîîåãôåäôïôèåÅôèåòîåôÌÁο
If the LAN cable has fallen out or a link is not established, some access points do not perform
wireless communications.
¼×èåîôèåÁÌÁÒÍÌÅÄìéçèôóÏξ
ǪÉóôåòíéîáìÓÓÉÄóåôôéîçôèåóáíåáóôèåáããåóóðïéîôÓÓÉÄóåôôéîçó¿¨Ð®³²²©
Please set the access point SSID and terminal SSID the same.
When the terminal SSID is set to "ANY" (blank), it may be unable to connect because of the
access point functions. Refer to the access point manual for more information.
ǪÉóôèåáõôèåîôéãáôéïîóåôõðãïòòåãô¿¨Ð®³²·©
Please set the access point Authentication System and terminal Authentication System settings
the same.
If in "SHARED" mode, please check the WEP settings.
ǪÐìåáóåãèåãëôèåÐòåáíâìåóåôôéîç®
XIT-100-BW's Preamble only support "Long" mode, please change the Preamble settings to
"Long" mode.
¼×èåîÁÌÁÒÍÌÅÄôõòîóïææïòâìéîëó¾
ǪÁòåôèå×ÅÐóåôôéîçóôèåóáíå¿
Are the WEP keys the same? ("Null," "40bits," "128bits")
Do the WEP's Tx KEY_ID and the WEP key match? (P.3-25)
ǪÄïåóî§ôáîáããåóóðïéîô÷éôèáóáíåãèáîîåìïòéîôåòæåòéîçãèáîîåìåøéóô¿
In the case where a non-interfering channel is set, a maximum of 4 access points can be used
in the one area.
ǪÉóî§ôôèå÷éòåìåóóôòáîóíéóóéïîâåéîçéîôåòæåòåäâùáîïâóôáãìå¿
Please check whether there is no equipment, such as a microwave oven or other WLANs etc,
which can cause interference.
Also, since a computer may act as a noise generation source, move the access point and termi-
nal away from the computer (1m or more).
ǪÁòåî§ôôèåòåáîùðòïâìåíó÷éôèôèåÔÃЯÉÐóåôôéîçó¨ÉÐáääòåóóåôã©¿¨Ð®³³³©
Check it to see if the terminal can connect to the computer by using the ping command etc.