User's Manual

Chapter 1 Hardware
1-16
1-6 Charging specification
1-6-1 Charging the Battery Pack
XIT-100-BW allows charging with a battery pack installed on the terminal by using dedicated charger
(QC-001/QC-002). Though the operation can be performed in this status, but be sure to avoid the key operation
lest it may fall or cause poor contact with the charging terminal.
1-6-2 Charging Method using Single Charger (QC-001)
When the XIT-100-BW and the battery pack are set at the same time, the XIT-100-BW charging has a priority.
After the XIT-100-BW charging completed, the battery pack charging starts.
The chargers can be connected by using the joint enclosed in the Single Charger (QC-001). (Limited to single
Charger). However carrying them as connected gives a large load on the joint fixed part, take care in handling.
When more than four chargers are connected, please use the Multi Charger (QC-002).
■Charging with the battery pack attached to the XIT-100-BW
During charging, the SCAN LED on the XIT-100-BW will turn ON red, when charging completed
turn ON green. Charging time is approximately 2.5 hours.
Take notes to the direction of the XIT-100-BW when set it on the charger.
Place the XIT-100-BW
in the charger as shown
below.
During charging SCAN LED red turn ON,
Charging complete SCAN LED green turn ON,
Charging Error SCAN LED turn OFF,
In case an error occurred during charging in the
state of running on, the screen on the right will be
displayed for 5 seconds, and then the power will
turn OFF.