User's Manual
Table Of Contents
- Contents
- 1 – General Information
- 2 – Setup
- 3 – Monitoring
- Perform ECG/RESP Monitoring
- Use the Propaq CS Monitor With Pacemaker Patients
- Perform Invasive Blood Pressure (IBP) Monitoring
- Take a Non-Invasive Blood Pressure (NIBP) Reading
- Perform Temperature Monitoring
- Perform SpO2 Monitoring
- Perform Mainstream CO2 Monitoring
- Perform Sidestream CO2 Monitoring
- Set Up the CO2 Display and Alarm Limits
- 4 – Alarms & Alerts
- 5 – Printing & Trends
- 6 – Acuity
- 7 – Defibrillator Synchronization
- 8 – Maintenance
- 9 – Reference
- Index
10 Protocol Systems, Inc.
Caution
Do not autoclave the Propaq CS monitor. Autoclave accessories only if the manufacturer's instructions clearly
approve it. Many accessories can be severely damaged by autoclaving.
Federal USA law restricts this device to sale, distribution, or use by or on the order of a licensed medical
practitioner.
It is possible for the monitor to detect a problem that prevents the monitor from operating properly. If
this occurs, the monitor displays an error message and error number. Report such errors to Protocol
Systems.
The Propaq CS monitor should be serviced only by a Protocol Systems service technician while under
warranty. The
Propaq CS Service Manual
(P/N 810-1101-XX) is available from Protocol Systems to
assist the biomedical engineer during post-warranty period service.
Controls and Connectors
Mainstream
CO
2
Option
Nurse Call
Option
Printer Buttons
Alarm(s) Off Light
Alarm Light
Sidestream
CO
2
Option
Printer
Option
SpO
2
Option
Starts or stops NIBP
reading
Suspend/
Resume
Alarm
Returns the display to
the Main Menu
Suspends alarm tone
for 90 seconds or
resumes alarm tone
(if active)
Start/
Stop
NIBP
Home