User's Manual
Table Of Contents
- Contents
- 1 – General Information
- 2 – Setup
- 3 – Monitoring
- Perform ECG/RESP Monitoring
- Use the Propaq CS Monitor With Pacemaker Patients
- Perform Invasive Blood Pressure (IBP) Monitoring
- Take a Non-Invasive Blood Pressure (NIBP) Reading
- Perform Temperature Monitoring
- Perform SpO2 Monitoring
- Perform Mainstream CO2 Monitoring
- Perform Sidestream CO2 Monitoring
- Set Up the CO2 Display and Alarm Limits
- 4 – Alarms & Alerts
- 5 – Printing & Trends
- 6 – Acuity
- 7 – Defibrillator Synchronization
- 8 – Maintenance
- 9 – Reference
- Index
Propaq CS Directions for Use 113
Reference
Power Specifications
Printer Mechanism
Printing Method Thermally sensitive dot method
Dot structure 320 dots per line
Printing width 53 mm
Horizontal Dot Pitch 0.165 mm, 6 dots/mm
Vertical Dot Pitch 0.165 mm
Paper Feed Method Friction Feed
Paper Feed Precision ±2% @ 25° C and 60% Relative Humidity
Paper Width 60 mm
Reliability 30 million pulses/dot
Environmental
Monitor/Expansion Module
Operating Temperature +5° to 40° C
Shipping and Storage Temperature -20° to 60° C
Operating Relative Humidity 35% to 85% noncondensing
Shipping, Storage Relative Humidity 15% to 90% noncondensing
Operating Altitude -2,000 to 15,000 ft (-610 to 4,572 m)
Shipping and Storage Altitude -2,000 to 40,000 ft (-610 to 12,192 m)
Shock 30 g
Vibration, Random 0.02 g
2
/Hz from 10 to 500 Hz, ramping down to 0.002 g
2
/Hz at 2000
Hz. Operating 1 hour per axis, 3 hours per test.
Electromagnetic Compatibility (EMC) Per IEC/EN 60601-1-2, which is a collateral standard of IEC/EN
60601-1, for electromagnetic compatibility.
Paper Storage
Short-term Storage Environment
(up to 7 days)
-20 to 40°C; 5% to 80% noncondensing
Long-term Storage Environment
(up to 5 years)
25°C (optimal), 65% noncondensing
Characteristic Specification
Mode of Operation Continuous
Battery Pack Type Sealed, gel-type lead acid
Battery Pack Capacity Monitor only: 8 V, 2.7 Ampere-Hours; Monitor with Expansion Modules: 8
V, 5.4 Ampere-Hours
Battery Recharger Circuitry Internal, powered by external power adapter
DC Input Power Required 12 to 28 V, 25 Watts
Input Fuse Rating 3A/250V, Type 2AG (0.57x 0.177 in)
Operating Times on Battery Typically 2 hours for monitor without Expansion Module, about 3 hours
for monitor with Expansion Module with printer, SpO
2
and CO
2
options,
and about 4 hours for monitor without Expansion Module but with the
SpO
2
option.
Battery Recharge Time with
instrument on
Range of 8 hours to 12 hours typical, depending upon product
configuration
Battery Recharge Time with
instrument off
Range of 6 hours to 8 hours depending upon product configuration
Recharge time until monitor is
usable, starting with discharged
but non-faulty battery
≤ 2 minutes typically (longer time required before NIBP, printer, and CO
2
are available)
Characteristic Specification