User's Manual

Propaq CS Directions for Use 115
Index
Index
A
AC Power Adapter
Change fuses 88
Change voltage selection 88
Connect to monitor 87
AC power adapter, specifications 114
AC power filter for ECG 31
Acuity
Connect the monitor to Acuity 75
Connector 11
Disconnect the monitor 76
Print at Acuity printer from monitor 76
Warnings 75
Acuity network equipment alert message 62
Airway adapter, Mainstream CO2 44
Alarm Holdoffs 109
Alarm indicators, specifications 109
Alarm Limits
Adjust after alarm 53
CO2 49
Customize alarm limits (STAT SET) 54
Setup 21
Alarm Limits Menu 21
Alarm Tone volume 20
Alarms
Adjust alarm limits 53
Automatic printing on alarm 70
Nurse Call Alarm 55
Patient Alarm Menu 53
Respond to patient alarms 53
Resume alarms 53
Setup alarm limits 21
Setup alarms 21
Specifications 109
Suspend or cancel alarms 53
Alarms Status Menu 21
Alert, equipment problem 56
Apnea
Automatic printing on apnea alarm 70
Apnea alarm 21, 53
Apnea measurement 44, 46
Apnea ticket (printout) 70
Artifact interference and waveform display 28
Artifact marker on display, prints (NIBP) 37
Artifact reduction with C-LOCK (SpO2) 42
Artifact reduction with SMARTCUF (NIBP) 36
Artifact with NIBP 7, 38, 39, 67, 68
Audible alarms 110
Automatic intervals (NIBP) 39
Automatic NIBP measurements 39
B
Bandwidth selection, ECG 31
Battery
Long-term storage precautions 92
Low battery message 63, 87
Recharging 87
Recycling 92
Beeper loudness 20
Brightness display control 20
C
Cannula for Sidestream CO2 47
Capnography(see Mainstream CO2 and Sidestream CO2)
Caution statements, general 9
Centigrade temperature units 40
Change alarm limits 21
Charge battery 87
Cleaning instructions 91
Clock setting 95
C-LOCK, SpO2 measurement 42
CO2
Alarm limits 49
Equipment alert messages 60, 61
Flowrate, Sidestream CO2 49
Gas compensation 49
Mainstream CO2 44
Response time 49
Select measurement units 96
Set up CO2 display 48
Sidestream CO2 46
Source selection 49
Specifications, general 106
Sweep speed selection 48
Connector locations 10
Connectors, patient 12
Continuous printing 70
Controls 10
Cuff inflation target (NIBP) 36
Cuff selection (NIBP) 37
Current patient mode 22
Custom patient modes 23
Customize alarm limits 54
D
Data communication equipment alert message 62
Date and time setting 95
Date format setting 96
Decimal character setting 96
Default inflation pressure (NIBP) 36
Default settings 97
DEFIB FAULT message 63
Defib Sync (see Defibrillator Synchronization)
Defibrillator Synchronization
Connector 11
Equipment alert messages 63
Install LIFEPAK 5 Interface Cable 79
LIFEPAK 5 defibrillator 79
LIFEPAK 6s defibrillator 82
Remove LIFEPAK 5 Interface Cable 81
Specifications 101
Sync marker display 80
Warning with LIFEPAK 5 79
Warning with LIFEPAK 6s 82
Delete all patient trends 69
Disconnect monitor from Acuity 76
Disinfection instructions 91
Display
Artifact interference 28
Brightness control 20
CO2 48