User's Manual
Table Of Contents
- Contents
- 1 – General Information
- 2 – Setup
- 3 – Monitoring
- Perform ECG/RESP Monitoring
- Use the Propaq CS Monitor With Pacemaker Patients
- Perform Invasive Blood Pressure (IBP) Monitoring
- Take a Non-Invasive Blood Pressure (NIBP) Reading
- Perform Temperature Monitoring
- Perform SpO2 Monitoring
- Perform Mainstream CO2 Monitoring
- Perform Sidestream CO2 Monitoring
- Set Up the CO2 Display and Alarm Limits
- 4 – Alarms & Alerts
- 5 – Printing & Trends
- 6 – Acuity
- 7 – Defibrillator Synchronization
- 8 – Maintenance
- 9 – Reference
- Index
Propaq CS Directions for Use 67
Printing &
Trends
Print Patient Data
Print the Displayed Waveforms
1. Press SNAPSHOT or START/STOP. The Propaq CS monitor prints up to three of the displayed
waveforms.
When four waveforms are displayed, the monitor prints the top three displayed waveforms (except
for the ECG2 waveform which is never printed).
If you pressed
START/STOP, the monitor continues to print until you press START/STOP again.
Note
This symbol indicates the NIBP reading was taken in the presence of high artifact while monitoring ECG with the
Smartcuf motion artifact filter on. Artifact can affect accuracy. To help reduce artifact, see page 39, step 6.
START
STOP
SNAP
SHOT
PRINT
TRENDS
Manually starts and stops a printout of patient
information as it is monitored (continuous or
real time).
Prints all trends that are enabled in the Printer
Setup Page (see page 69).
Prints the last 8 seconds of data for
nonrespiration waveforms and 32 seconds of
compressed waveform history for respiration
waveforms.
The numerics across the top of the printout
apply to the moment you press
SNAPSHOT.
Printer Buttons