User's Manual
Table Of Contents
- Contents
- 1 – General Information
- 2 – Setup
- 3 – Monitoring
- Perform ECG/RESP Monitoring
- Use the Propaq CS Monitor With Pacemaker Patients
- Perform Invasive Blood Pressure (IBP) Monitoring
- Take a Non-Invasive Blood Pressure (NIBP) Reading
- Perform Temperature Monitoring
- Perform SpO2 Monitoring
- Perform Mainstream CO2 Monitoring
- Perform Sidestream CO2 Monitoring
- Set Up the CO2 Display and Alarm Limits
- 4 – Alarms & Alerts
- 5 – Printing & Trends
- 6 – Acuity
- 7 – Defibrillator Synchronization
- 8 – Maintenance
- 9 – Reference
- Index
90 Protocol Systems, Inc.
Install Printer Paper
Caution
Use only low-debris printer paper listed in the Protocol Systems Products and Accessories booklet. Use of
other paper can cause unclear printing of patient data, printhead damage, and eventual printer failure. Store all paper
(including a monitor loaded with paper) in compliance with paper storage specifications (see page 113).
1. Lay the monitor on its back to gain access to the bottom of the printer.
2. Squeeze the locks on the paper door and pull out to open it.
3. Lift the paper roll from the holder and pull out any paper remaining in the printer.
4. Place the new paper roll onto the spindle on the door as shown, and pull out several inches of
paper.
5. Slide the end of the paper into the printer slot until it extends out the side.
6. Close the paper door and turn the monitor upright.
7. Simultaneously press the START/STOP and PRINT
TRENDS button. Confirm the monitor prints a test
print similar to the following: