User's Manual
Table Of Contents
- Contents
- 1 – General Information
- 2 – Setup
- 3 – Monitoring
- Perform ECG/RESP Monitoring
- Use the Propaq CS Monitor With Pacemaker Patients
- Perform Invasive Blood Pressure (IBP) Monitoring
- Take a Non-Invasive Blood Pressure (NIBP) Reading
- Perform Temperature Monitoring
- Perform SpO2 Monitoring
- Perform Mainstream CO2 Monitoring
- Perform Sidestream CO2 Monitoring
- Set Up the CO2 Display and Alarm Limits
- 4 – Alarms & Alerts
- 5 – Printing & Trends
- 6 – Acuity
- 7 – Defibrillator Synchronization
- 8 – Maintenance
- 9 – Reference
- Index
Propaq CS Directions for Use 95
Reference
Set the Time and Date
1. From the Main Menu press SETUP, MORE, MORE to display the Time/Day window:
2. Press NEXT, UP, and DOWN as needed to set the time and date. Then press ENTER to store the
new time and date.
Time/Day Settings and Trends
Warning
Changing the hour/minute/second setting for the monitor in the Time/Day window can cause the monitor to
erase previously stored patient trend data.
When you change the hour/minute/second setting for the monitor in the Time/Day window, the
monitor deletes any patient trend data that is older than five hours for non-NIBP trends or older than
eight hours for NIBP trends according to the new clock setting.
However, if the monitor has not yet stored the full capacity of trends and you change the
hour/minute/second setting to a time that is within the stored trend period, previously stored trends
are not erased.
Changing the day, month, or year setting does not affect the stored patient trends.
BR
TEMP
100.4
98.6
1.8
97
( 85)
mmHg
(
M
)
%
°F
58
MCO2
S
p
O2
mmHg
38
Br/m
D
NEXT
T1
T2
∆T
SERVICE
TIME DAY
UP DOWN ENTER
H:MIN:S
15:55:10
MO/DA/YR
10/21/99
12