Installation - Quick Reference Guide Owner's manual

The recorder is ready to take a BP measurement.

You can give the recorder any name that you find helpful.

Press the Start/Stop button to turn the recorder on.

Press the Start/Stop button again to start the BP pump.

Press the Start/Stop button again to stop the BP pump.

When BP stops, verify that the recorder displays an error code

(“E” followed by a number).

Press and hold the Start/Stop button until you hear a series of

quick beeps (approximately 7 seconds) to turn the recorder off.

Attach the cable to the recorder.

Start/Stop button

The recorder turns on. (It turns on and off auto-

matically throughout this procedure.)

Disconnect the cable from the recorder.

(next page)