Specifications

3–86
Additional Programming
3.10 Wand Emulation and Laser Output Programming
Use this section to program the 3400 for Wand Emulation
and Laser Output selections. Scan the bar codes below
to default the 3400 to factory settings (✽) for wand
emulation and laser output selections.
➊ ENTER Wand Emulation and Laser Output
Program Mode
➋ DEFAULT All Wand Emulation and Laser
Output Selections
➌ EXIT Wand Emulation and Laser Output
Program Mode
3400–X3 and 3400–18 units do not support Wand
Emulation and Laser Output.