Specifications

3–89
Additional Programming
❖ Data Sync / Wake Up Selection [
➊ ENTER Program Mode
Scan the bar code below to program Data Sync / Wake Up
Signal, then choose enable or disable.
➋ Data Sync / Wake Up Signal
➌ Enable (Yes)
➌ Disable (No ✽)
➍ EXIT Program Mode
Default = Off (Disable / No). If enabled, the scanner
generates a sync / wake up pulse when the trigger switch is
activated to alert the decoder or portable terminal that digital
bar code data will follow. The bar code data is transmitted
after a 200 millisecond delay from the start of pulse.
 







  


  

 
  
[ A unique wand emulation cable is required to support this feature.
Refer to the IPWC Interface/Cable Matrix for the cable part number.