Specifications

3–91
Additional Programming
3.12 SCANTEAM 3400 Cloning Instructions
Procedure:
1) Connect the 4 pin female mini–DIN on the cloning cable
(p/n 42204559–01) to the power supply (PS5/C).
2) Connect the SOURCE* unit to one of the 10 pin
modular connectors on the cloning cable.
3) Connect the DESTINATION* unit to the remaining 10
pin modular connector on the cloning cable. Scan the
“Destination” cloning bar code.
“Destination” Cloning Bar Code
4) Scan the “SOURCE” cloning bar code. The unit’s green
LED will flash on and off. This process takes about 15
seconds.
“Source” Cloning Bar Code
5) When cloning is complete, the SOURCE* unit will flash
its green LED on and off.
6) Unplug the DESTINATION* unit from the cloning cable.
7) To clone another unit, repeat steps 3 through 5.
*Note: The SOURCE unit is the unit containing the desired
firmware. The SOURCE unit may be an original “Master”
unit, or a unit that has been cloned from the “Master” unit.
The DESTINATION unit is the unit which needs to be
updated from the SOURCE or “Master” unit.
Caution: DO NOT scan the “source” bar code unless you are
going to clone a unit. If you do, you may lock up your
unit and will have to turn the power off and back on.