Specifications

2–1
Quick Start Programming
2
QUICK START PROGRAMMING MENU
2.1 Introduction
Use this chapter to program the SCANTEAM 3400 Hand
Held CCD Scanner to work with your terminal/computer.
❖ About “Plug and Play” Programming
With “Plug and Play” programming (Section 2.2), you
connect the 3400 and scan
only one bar code to program
the scanner (including required prefixes/suffixes).
❖ About Terminal Selection Programming
With Terminal Selection programming (Section 2.3), you
program the 3400 for any supported terminal/computer.
❖ Program Carriage Return (CR) Suffix
Use the single bar code in Section 2.4 to program a
carriage return suffix in the 3400.
❖ To Clear Bar Code Suffix
Use the single bar code in Section 2.5 to clear bar code
suffix in the programmed 3400.
❖ To Reset Factory Default Settings
Use the single bar code in Section 2.6 to reset the 3400
to factory default settings.
❖ Additional Programming Options
If you need additional programming options, refer to
Chapter 3 to configure the 3400 to:
• selective factory default settings
•
any variation of the programmable features available.