Specifications

2–16
Quick Start Programming
Supported Terminals, continued
Terminal Model(s) Terminal I.D.
OCIA 52
OCR 53
Olivetti M19, M24, M28, M200 01**
Olivetti 240, 250, 290, 380, P500 03**
Qume ANSI QVT 61, 62, 70, 191, 321, 322 82
Qume ASCII QVT 31, 51, 61, 62, 70, 191 74
Qume Enhanced PC QVT 61, 62, 70, 82, 191, Qx15 38
RS232 True 00
RS232 TTL 00**
Serial Wedge* 50
Siemens 9758 (German Only) 34
Stratus V103 14
Televideo 955, 965 36
Telex 88 Key 078A, 078, 79, 80, 191, 196, 25
1191, 1192, 1471, 1472, 1476
Telex 102 Key 078A, 078, 79, 80, 191, 196, 45
1191, 1192, 1471, 1472, 1476
Telex 122 Key 078A, 078, 79, 80, 191, 196, 46
1191, 1192, 1471, 1472, 1476
Wand Emulation 61
WYSE WY–30 13
WYSE WY–85/185 16
WYSE ANSI[ WY 60, 120, 150, 160 15
WYSE ASCII[ WY 60, 120, 150, 160, 99GT 14
WYSE Enhanced PC[ WY 60, 120, 150, 160 18
* Only supported by 3400–X3 units.
** The 3400–18 only supports Olivetti M19, M24, M28, M200, Olivetti 240, 250,
290, 380, P500, and RS232 TTL.
[ Wyse 60 requires a 40 millisecond intercharacter delay. Refer to In-
tercharacter Delay on page 3–26 : Scan Enter, Intercharacter Delay
Selection, 0, 8 (x5ms), and Exit.
❖ Terminal Selection Menu
Scan the bar code below to program a terminal interface.
  