Specifications

3–1
Additional Programming
3
ADDITIONAL PROGRAMMING SELECTIONS
If you’ve already programmed the 3400 using “Plug and Play”
or Terminal Selection (Chapter 2), you don’t need to continue
programming the 3400 (unless you need to set other features).
3.1 Introduction
Use this chapter to program the SCANTEAM 3400 Hand
Held CCD Scanner for
any programmable feature.
Additional programming selections include:
• Prefixes and Suffixes
• Dual Interface (set up for two different applications)
• Output (beeper, delays, output mode, country codes)
• Industrial Symbologies
• Retail Symbologies
• RS–232 (baud rate, parity, data format, protocols)
• Data Formatter (Bar Code Editor)
• CCD Operation
• Wand Emulation and Laser Output
• Status Check.
After you’ve programmed the SCANTEAM 3400, the
information represented by the programming bar codes is
stored in the scanner’s nonvolatile (EEPROM) memory. If
you turn the scanner off, nonvolatile memory retains the
programmed features.