Specifications

3–2
Additional Programming
❖ Programming Instructions
Resetting Default Settings
The first page of each programming section allows you to
program the SCANTEAM 3400 to factory settings
for that
particular section. This is useful if you’ve changed the
features (or don’t know what’s been programmed) and
want to reset the 3400 defaults, but not
all its defaults.
To reset the 3400 to factory settings for a particular
programming section, turn to that section and:
➊ Scan the “ENTER” bar code to enter programming
mode.
➋ Scan the “DEFAULT” bar code to set factory settings.
Factory settings are indicated by “ ✽ ” (asterisks).
➌ Scan the “EXIT” bar code to exit programming mode.
Changing Settings
To change the default values, turn to the programming
selection you want to change:
➊ Scan the “ENTER” bar code to enter programming
mode (unless noted otherwise).
➋ Scan the Selection bar code ( the bar codes toward
outside edge of page
).
➌ Scan the option bar code ( centered on page ) to make
your programming choice, then scan “EXIT.”
Programming sequence is numbered (➊, ➋, ➌, etc.) next to bar
code, bar code title, or text describing bar code.