Specifications

3–50
Additional Programming
❖ Code 128 Selection
➊ ENTER Program Mode
Scan the bar code below to start Code 128 symbology
selection, then enable or disable Code 128 decoding.
➋ Code 128 Selection
➌ Enable (Yes ✽)
➌ Disable (No)
Note: If you don’t need to program additional selections, you may
scan EXIT now to exit program mode and save your changes.
To set minimum allowable length, scan the “Set Minimum
Length” bar code, then refer to the Industrial Symbologies
Min/Max Length chart (page 3–52). Scan two of the Numeric
Bar Codes (below the Length chart) to set the length.
Repeat
the process to set maximum length.
➌ Set Minimum Length
➌ Set Maximum Length