Specifications

8–3
SCANTEAM 2010 User’s Guide
MSR Connector:
RJ–45 8 Pin Modular

1
2
3
4
5
6
7
8

Ground
Mag clock 3
VCC (+ 5V)
Mag clock 2
Mag data 2
Mag data 3
Mag data 1
Mag clock 1
Scanner Connector:
9 Pin D Male

1
2
3
4
5
6
7
8
9

SOS input
TTL digital input (data in)
Good read output
No connection
Laser trigger input
Laser enable output
Ground
Shield ground
+ 5VDC (VCC)
Scanner / Auxiliary RS-232D (Port 1) Connector
The scannerĂ/Ăauxiliary RSĆ232D connector supports the attachment of a +5
volt nonĆdecoded output scanner or an RSĆ232 auxiliary input device. The
decoder is compatible with all Welch Allyn contact and nonĆcontact bar code
scanners, including bar code contact wands, lasers, and CCDs. The decoder
will beep once after valid scanner or auxiliary device input. Three beeps indicate
an invalid auxiliary device input. Pinouts are shown above.
Aux RS-232D (Port 1) Connector:
9 Pin D Male

1
2
3
4
5
6
7
8
9

RxD input
RTS output
No connection
No connection
CTS input
TxD output
Ground
Shield ground
No connection
 Switching from scanner to RS-232D input requires cable part number
42205531-xx. Turn the unit off, then on again after changing the input device.