Specifications

9–3
SCANTEAM 2010 User’s Guide
Does the decoder read your bar code incorrectly?
If the decoder reads a bar code (one beep for a good read), but the bar
code is not displayed correctly on the host screen:
➊ The decoder may not be programmed for the appropriate terminal
interface.
 You scan 12345" and the host displays @es%."
Reprogram the decoder with the correct Plug and Play" or Terminal
Selection bar code (see Section 2, Quick Start Menu).
➋ The decoder may not be programmed to output your bar code
properly.
 You scan 12345" and the host displays A12345B."
Reprogram the decoder with the proper Symbology selections (see
Section 5, Symbology Menu).
The decoder won’t read your bar code at all?
If the decoder will not read your bar code:
➊ Try scanning the Sample Bar Codes (found near the end of the User's
Guide).
If the decoder reads
the Sample Bar Codes, check that your bar code
is readable. (See Is the decoder having trouble reading your bar
codes" on the previous page.)
If the decoder does not read
the Sample Bar Codes either, continue
to #2, below...
➋ If the decoder won't read the Sample Bar Codes either:
Verify that the bar code symbologies are enabled. (See Sections 5,
Symbology Menu.)
Verify that your bar code symbology is enabled. (See Sections 5,
Symbology Menu.)
Scan the Default All... " bar code on each symbology menu page in
Section 5 to enable most symbologies. (MSI and Plessey will have to
be enabled individually, as they are defaulted .)