Specifications

2–1
SCANTEAM 2010 User’s Guide
Introduction
Use this chapter to program the Keyboard WedgeĂ/ĂCommercial Decoder to
work with your terminalĂ/Ăcomputer.
About “Plug and Play” Programming
With Plug and Play" programming, you connect the decoder and scan only one
bar code to program the decoder (including required prefixesĂ/Ăsuffixes).
About Terminal Selection Programming
With Terminal Selection programming, you program the decoder for any
supported terminalā/ācomputer.
 Before programming your decoder, follow instructions in Section 1 to
unpack and connect the decoder.
About Main Menu Programming
With Main Menu programming, you reset the factory default settings, set and
save customer defaults, print out a status check, or abort programming
changes.
This programming section contains the following menuing selections:
• Plug and Play Selections.
• Terminal Interface Selections.
• Main Menu Selections.
Additional Programming Options
If you need additional programming options, refer to Sections 3 (Serial Interface
Menu), Section 4 (General Operating Menu), or Section 5 (Symbology Menu)
to configure the decoder to:
• selective factory default settings
• any variation of the programmable features available.