Specifications

3–10
SCANTEAM 2010 User’s Guide
Scanner Function Code Transmit
RS-232D Function Code Transmit
When this programming selection is enabled, and function codes are contained
within the scanned data from the scanner, the decoder transmits the key code
(which corresponds to the decoded ASCII function code) to the terminal. If this
selection is disabled, any function codes contained within the scanned data are
not sent to the terminal.
ASCII function codes are represented by the HEX values 00-1F. (Charts of
these function codes are shown in Section 7, Supported Interface Keys.)
Default = Enable.
When this programming selection is enabled, and function codes are contained
within the scanned data from the RSĆ232D device on the auxiliary data input
port, the decoder transmits the key code (which corresponds to the decoded
ASCII function code) to the terminal. If this selection is disabled, any function
codes contained within the input data are not sent to the terminal.
ASCII function codes are represented by the HEX values 00-1F. (Charts of
these function codes are shown in Section 7, Supported Interface Keys.)
Default = Enable.
Code I.D. Transmit
This programming selection allows you to enable or disable transmission of a
Code I.D. before the decoded bar code symbology. (See the Symbology Chart
on page 3-5 for the single character code that identifies each symbology.)
Default = Disable.
 More RSĆ232D programming may be found in Section 4, Serial
Communications Menu.