User's Manual Part 2

50 Chapter 6 Reference Welch Allyn Micropaq Monitor
Specifications
Monitor radio specifications (5 GHz)
Monitor radio specifications (2.4 GHz)
Characteristic Specification
FlexNet™ Network 5 GHz orthogonal frequency division multiplexing (OFDM) wireless local area network
(WLAN) and 10/100/1000 base
-T Ethernet network
Modulation OFDM
Output power 40 mW maximum; country-dependent
IEEE standards 802.11a, 802.11e, 802.11h, 802.1X
Monitors per access point 20 (max.)
Restrictions for use in the 5 GHz bands
a
a. This device may be not be operated outdoors when using the bands 5150 to 5350 MHz (Channels 36, 40, 44, 48, 52, 56, 50, 64).
Allowed frequency bands
b
b. This device must be used with Access Points that have employed and activated a radar detection feature required for European
Community operation in the 5GHz bands. This device will operate under the control of the Access Point in order to avoid operating
on a channel occupied by any radar system in the area. The presence of nearby radar operation may result in temporary interruption
in communications of this device. The Access Point’s radar detection feature will automatically restart operation on a channel free
of radar. You may consult with the local technical support staff responsible for the wireless network to ensure the Access Point
device(s) are properly configured for European Community operation.
Allowed channel numbers
c
c. To remain in conformance with European spectrum usage laws for Wireless LAN operation, the above 5 GHz channel limitations
apply. The user should check the current channel of operation. If operation is occurring outside of the allowable frequencies as
listed above, the user must cease operating the device at that location and consult the local technical support staff responsible
for the wireless network.
Countries
5.15 to 5.25 GHz 36, 40, 44, 48 Austria
5.15 to 5.35 GHz 36, 40, 44, 48, 52, 56, 60, 64 Cyprus, Czech Republic, France,
Hungary, Slovakia
5.15 to 5.35 GHz
and 5.470 to 5.725 GHz
36, 40, 44, 48, 52, 56, 60, 64, 100,
104, 108, 112, 116, 120, 124, 128,
132, 136, 140
Belgium, Bulgaria, Denmark,
Estonia, Finland, Germany, Greece,
Iceland, Ireland, Italy
d
, Latvia,
Liechtenstein, Lithuania,
Luxembourg, Malta, Netherlands,
Norway, Poland, Portugal, Slovenia,
Spain, Sweden, Switzerland, U.K.
d. In Italy the end-user must apply for a license from the national spectrum authority to operate this device outdoors.
Characteristic Specification
FlexNet Network 2.4 GHz Wireless Local Area Network (WLAN) and 10/100 Base-T Ethernet
network
Frequency
a
a. When used within certain countries, authorization for use is restricted as follows:
France: The equipment is internally restricted to the 2.448-2.482 GHz frequency range.
Spain: The equipment is internally restricted to the 2.447-2.473 GHz frequency range.
Japan: The equipment is internally restricted to the 2.473-2.495 GHz frequency range.
Italy: Operation requires a user license.
Note: The frequency ranges specified above are subject to geographic-specific regulatory authorities.
2.402 to 2.480 GHz
Modulation Frequency Hopping Spread Spectrum (FHSS)
Output Power 100 mW
IEEE 802.11 compliant Yes
Monitors per Access Point 15 (maximum) in most countries. In countries where available frequencies
are limited, this number is reduced.