Manual

Operation. 13
G. Check before asking warranty service
Q: Power doesn't come out.
A: Connect power cord correctly and press power switch.
Q: Screen doesn't come out.
A: Check that monitor of signal cable(D-Sub) is connected correctly.
Q: LED of monitor is blinking.
A: Check that monitor of signal cable(D-Sub) is connected correctly.
Q: The size and position of screen is not normal.
A: Activate auto on screen display.
Q: Screen is too bright or dark.
A: Adjust brightness or contrast on screen display.
Q: The letter on screen is not clear and noise comes out.
A: Make it be optimal by adjusting "Phase" on display adjust.
Q: Screen doesn't come out clearly.
A: Adjust vertical frequency in registration information of system display.
If the symptom happen continuously, adjust by changing video card.
Q: No signal is shown up.
A: Check signal cable(D-Sub) of monitor(S-Sub) and the condition of damage.
Q: An image is turned up, but sound doesn't come out.
A: Check program from other broadcast and press volume up button.
Q: Screen of whole channel or special channel is overlapped.
A: Adjust the position and direction of antenna.
Q: Sound doesn't come out from speaker.
A: Check that audio cable is connected with audio in port of monitor and sound card
speaker of PC.
Q: Screen doesn't turn up after changing to our monitor from previous one.
A: Install new monitor(ours) after changing to frequency supported by out monitor on
registration information of window display from previous one.
WDL-1500M/1700M/1900M