Installation guide



Wellav Technologies Ltd.
15
UMH 160 Quick Installation Guide
V1.1-W
enter the configuration menu.
z Enter “Menu”:
 Press “MENU
” button to enter main menu.
z Exit Menu/Back to parent Menu
 Upon completion of configuration settings, press “MENU
” button until you go back
to the Parent Menu.
 You can also go back to Parent Menu directly by pressing “ESC
” button once.
z Enter Sub-Menu
 Press MENU
button to enter main menu.
 Select a sub-menu by pressing UP
and DOWN button.
 Press OK
button on the selected sub-menu.
z To change parameter
 Step 1: Enter main menu by pressing MENU
button.
 Step 2: Scroll sub-menu by pressing UP and DOWN button, and press OK button
to change the selected sub-menu.
 Step 3: To change parameter settings, press RIGHT
and LEFT button to move the
cursor in which change must be made.
 Press UP
button and DOWN to input / select an appropriate setting, then press OK
button to save.
6.2.2 Check Out and Change the Default IP Address
z Step 1: check out the IP on the LCD screen.
z Step 2: use the button on the front panel to change the IP, gateway and subnet mask.
The gateway should be the same as the management PC’s. The subnet mask should
be the same as the management PC’s s. The IP and the server’s IP should be in the
same section.
z Step 3: reboot the device to take effect.
z Step 4: ping the new IP on PC to check whether the device can connect to the
management PC.