Installation guide
Wellav Technologies Ltd.
19
UMH 160 Quick Installation Guide
V1.1-W
PIC-6-3-2
z Tuner IN
If you need to receive the signal from satellite via the device, just connect the satellite siganl
to the tuner port and operate as follows:
-Step one:
PIC-6-3-3
Choose the signal as input ,there are three options:ASI, Tuner and IP, here we choose tunel
as siganl source. After confirm the signal source, it is able to go for further configuration.
-Step two:
Configure the dual RF receiver parameters including the Satellite Frequency, Symbol Rate,
LNB Frequency, and LNB Voltage (Polarization) with accurate values to ensure a successful
receiving. You can get the value for the parameter from the satellite operator
Stepone
Steptwo
Stepfour
Stepthree