Installation guide



Wellav Technologies Ltd.
23
UMH 160 Quick Installation Guide
V1.1-W
PIC-6-3-7
-Step Three
Then, set the “Enable” item to be “ON” to access the IP channel and set the source IP
address, Source Port and Protocol. The Source IP address shall be in the same section with
that of signal source, and the Source Port and protocol shall stay same with that of signal
source.
-Step Four
Press “Submit” button to confirm the parameter. And press the “Status” menu in the left area
to refresh the receiving information to check if the signal is locked.
6.3.3 Configure parameters of signal output modules
z Decoder OUT
The device allows various signal outputs, including HDMI, SDI, CVBS. In this interface, user
can view and configure the decoding output program information, including: Video, Audio,
and HDMI/SDI.
Steptwo
StepThree