Installation guide



Wellav Technologies Ltd.
27
UMH 160 Quick Installation Guide
V1.1-W
IPSourcePort and UDPDestProtocol. The IPDestAddress is the address which you want to
send the streams to. (Refer to chapter 6.3.3.3)
Enable the FEC function and set the parameters, if you want this Function.
ColFEConly: No means both Col and Row FEC; Yes means Col FEC only.
-Step Four
Here it it able to check the programs that converted in the IP channel.
6.3.3.3 Multicast and unicast for IP
z multicast application
In multicast application, it is simple to connect the physical equipment, and the following
picture shows a typical connection and parameters setting. You just need set the parameters
listed in this picture.
PIC-6-3-15
The important point is to make sure the multicast address, protocol and port number are the
same in both ‘IRD_Sender’ and ‘IRD_Receiver’. Regarding how to enter the menu to set
these parameters, please refer to the chapter ‘front panel/NMS control and operation’.
Note: