User Manual

20
GB
Specied Conditions Of Use
Applied directives
The Weller Zero Smog volume
fume extraction system
extraction unit corresponds to
the EC Declaration of
Conformity in accordance with
the basic safety requirements
of Directives 2004/108/EC,
2006/95/EC and 2011/65/EU
(RoHS).
This ltration system is suitable for the extraction and ltration of partic-
les and gases, depending on the lter medium used.
Warning! Danger of asphyxiation, Danger of poiso-
ning
Improper use may result in respiratory problems, asphy-
xiation, poisoning or cancer
 Particles and gases which are unsuitable for the lter
medium in use may not be extracted.
 Liquids and ammable gases may not be extracted
 Never use the device without a lter or with a full lter.
 Never use the device without the fan cover
This device may only be used at room temperature and indoors.
Zero Smog 4V, Zero Smog 6V: The unit is designed for use as a
surface extraction unit and is not suitable for extracting fumes direct-
ly from the soldering gun.
Zero Smog 20T: The unit is designed for extracting fumes directly
from the soldering gun and is not suitable for use as a surface
extraction unit.
Intended use of the soldering station/ desoldering station also inclu-
des the requirement that you
 adhere to these instructions,
 observe all other accompanying documents,
 comply with national accident prevention guidelines applicable at the
place of use.
The manufacturer will not be
liable for unauthorised modica-
tions to the device.
Efciency test
In accordance with the general guidelines of the trade association, fume extractor systems must be
checked regularly, at a minimum annually, in order to ensure that they are fully functional (TRGS 528
BGETF). The efciency test also serves to check for proper functioning of the WFE 2S / WFE 4S and
Zero Smog 4V / Zero Smog 6V / Zero Smog 20T solder fume extractor systems. Use the supplied soft-
ware CD.
User groups
Due to differing degrees of risk and potential hazards, several work steps may only be performed by trained
experts.
Work step User groups
Installation of complex pipe systems with multiple
extractor arms connected
Specialist personnel with technical training
Replacing electrical replacement parts Electricians
Specication of maintenance intervals Safety expert
Operation
Filter change
Non-specialists
Installation of complex pipe systems with multiple
extractor arms connected
Replacing electrical replacement parts
Technical trainees under the guidance and supervision
of a trained expert