User manual

ManualsBrandsWELLER ManualsSoldering AccessoriesSoldering fume extractor 110 Vdc, 240 Vdc 100 W 140 m³/h

OPERATING MANUAL

FILTRONIC

Apex Tool Group AB

Hissgatan 2, Box 2284, 531 02 LIDKÖPING

Tel: +46 510 208 10, Fax: +46 510 201 40

e-mail: office@filtronic.se

www.ltronic.se

Version 10

MG100S

Filter system

FOR A BETTER WORKBENCH ENVIRONMENT

OPERATING MANUAL

Version 1

Weller Tools GmbH

Carl-Benz-Str. 2

74354 Besigheim, Germany

Tel: +49 (0) 7143 580-0

Fax: +49 (0) 7143 580-108

www.wellerft.com

39077-1 / 09.2014

tiger_titel.indd 1 03.09.13 10:30

Summary of content (4 pages)

PAGE 1
OPERATING OPERATING MANUAL MANUAL MG100S e-mail: office@filtronic.se www.filtronic.se tiger_titel.indd 1 FOR A BETTER WORKBENCH ENVIRONMENT Version 1 Version 10 Weller Tools GmbH Carl-Benz-Str. 2 74354 Besigheim, FILTRONIC Germany Tel: Apex +49Tool (0) Group 7143 AB 580-0 Hissgatan 2, Box 531 02580-108 LIDKÖPING Fax: +492284, (0) 7143 Tel: +46 510 208 10, Fax: +46 510 201 40 www.wellerft.com 39077-1 / 09.2014 Filter system 03.09.
PAGE 2
Content 1. 2. 3. 4. 5. 6. 7. 8. 9. 9. Warranty Introduction Content Safety instructions Put into operation Troubleshooting Maintenance and service Technical data Article numbers Warranty General conditions according to ORGALIME S 2000. 2 2 3 3 4 5 6 6 7 Warranty:12year years (except for filters). The time is measured from date of invoice. Always contact the supplier before returning a product. The invoice has to be shown at the time of the complaint. 1.
PAGE 3
7. Technical data 3. Safety instructions Width x height x depth Weight Sound level at 1 meter Voltage Effect Glass tube fuse Maximum suction capacity Blower capacity Micro filter HEPA class H13, Separation degree, MPPS Gas filter - Separation degree Pre filter Filter minitoring system Warranty (excl.
PAGE 4
5. Troubleshooting 6. Maintenance and service 2. - the electricity supply is connected in a correct way. - the fuse is whole. 4. Open the locks (3) and remove the lid (2). Put the top (2) and the locks (3) back. 2 3 : See ”Exchange - If alarm sounds when starting and red indicator is lighted: Suction capacity is low. Restore the alarm with the reset button on the control panel and Check nozzles and tubes, clean if necessary. If the alarm comes back 2. Open the locks (3) and remove the lid (2). 4.