User Manual

4-6 HAP 200
3.1 Operating guidelines
Caution!
•
Z Always use Weller original hot air nozzles!
Z Use of Non-Weller nozzles may result in damage to the Hot Air
Tool and may void the warranty.
The HAP 200 is supplied with an 8 mm socket wrench. Use this
wrench to replace the nozzles. Tighten the enclosed nozzle adapter
on to the heater using the supplied open-end wrench.
Note The enclosed nozzle adaptor (5) (0058761028) allows the HAP 1
nozzles to be used on the HAP 200.
Replacement Hot Air Tools are preset at the factory and can be
connected and used without any need for readjustment.
To check the hot air temperature, it is recommended that you use a
special test nozzle (0058727808) which mates with a sheathed
thermocouple (Ø 0.5 mm).
4 Accessories
See Hot Air Nozzles in Section 6
5 Packing List
• Hot Air Tool HAP 200, 0052711699
• Operating Instructions
• Safety booklet
• Tool Stand WFH 30, 0051515299
• Nozzle Ø 3.0 mm, 0058727822
• Socket wrench for standard nozzle, 0058748862
• Nozzle adaptor M6, 0058761728
• Open-end wrench 8 mm across flats, 0058727826
6 Hot Air Nozzles
• 0058727823 – Round; 031“ (.80 mm)
• 0058727821 – Round; .047“ (1.20 mm)
• 0058727787 – Round; .098“ (2.50 mm)
• 0058727822 – Round; .118“ (3.00 mm)
• 0058727786 – Round Bent; .079“ (2.00 mm)
• 0058727782 – 2-Sides Heated; .394“ x .512“ (10 x 13 mm)
• 0058727781 – 2-Sides Heated; .394“ x .591“ (10 x 15 mm)
• 0058727784 – 2-Sides Heated; .394“ x .709“ (10 x 18 mm)