Owner's manual

ManualsBrandsWeller ManualsToolsWSD80

WSD80 SOLDERING STATION

1. Power switch

2. Digital display

3. UP button

4. DOWN button

5. Optical regulator (LED)

6. Connection for soldering iron

7. Power supply connector

8. Fuse/Holder

S1097ACH

REV. 11/01

WSD80 EXPLODED VIEW

WARNING: This product, when used for soldering

and similar applications, produces

chemicals known to the State of

California to cause cancer and birth

defects or other reproductive harm.

Summary of content (6 pages)

PAGE 1
WSD80 EXPLODED VIEW S1097ACH REV. 11/01 12 WSD80 SOLDERING STATION 1. Power switch 2. Digital display 3. UP button 4. DOWN button 5. Optical regulator (LED) 6. Connection for soldering iron 7. Power supply connector 8. Fuse/Holder WARNING: 1 This product, when used for soldering and similar applications, produces chemicals known to the State of California to cause cancer and birth defects or other reproductive harm.
PAGE 2
DESCRIPTION CONTROL UNIT The soldering station WSD80 is a part of the range of products which was developed for industrial manufacturing as well as for the repair and laboratory sector. A microprocessor makes operation simple and comfortable. The digital electronic control system guarantees the best possible control performance for various soldering tools. The soldering tools themselves are recognized automatically by the soldering station and assigned the corresponding control parameters.
PAGE 3
ACCESSORIES WSP80 Soldering iron set WSP80 (WSD80 only) WST20 Thermal Stripping Tool with Support WHP80 Heating Plate WT50 Heated Tweezer WCB1 Calibrator WCB2 Calibrator SCOPE OF SUPPLY Control unit Soldering iron WSP80 Power cable Operating instructions Soldering iron rest Illustration: Exploded view, see page 12.
PAGE 4
SETTING THE TEMPERATURE The digital display (2) shows the actual value temperature. By pressing the UP or DOWN key (3, 4) the digital display (2) switches to the set point. The set point (“flashing display”) can be changed by tapping or by firmly pressing the UP or DOWN button (3, 4) in the desired direction. Pressing the button will change the set point quickly. The digital display (2) returns automatically to the actual value approximately 2 seconds after releasing the button.
PAGE 5
14. Take care of your soldering tool. Keep the soldering tool clean for better and safer work. Follow the maintenance instructions and the notices concerning changing the soldering tips. Regularly inspect all connected cords and hoses. Repairs should only be carried out by a qualified technician. Use only original WELLER replacement parts. 15. Remove the power plug from the socket before opening the unit. 16. Remove all maintenance tools.
PAGE 6
These operating instructions and warnings should be read carefully and kept in an easily accessible location in the vicinity of the soldering iron. Non-observance of these warnings can result in accidents, injury or risks to your health. WARNINGS 1. Keep your work area in proper order. Always return the soldering tool to its original holder when not in use. Do not bring combustible materials near the hot soldering tools 2. Take care for the surroundings.