Datasheet

16
Soldering and desoldering
Carry out soldering work as directed in the operating instructions of your connected soldering tool.
Handling the soldering tips
• Coat the selective and tinnable soldering tip with solder
when heating it up for the rst time. This removes oxide
coatings which have formed during storage and impurities
from the soldering tip.
• Make sure that the soldering tip is well coated with solder
during breaks between soldering work and prior to storage
of the device.
• Do not use aggressive uxing agents.
• Always make sure that the soldering tips are tted properly.
• Select as low a working temperature as possible.
• Select the largest possible soldering tip shape for the
application.
Rule of thumb: the soldering tip should be roughly as large
as the soldering pad.
• Coat the soldering tip well with solder to ensure that there
is efcient heat transfer between the soldering tip and the
soldering area.
• Prior to extended breaks between soldering work, switch
off the soldering system or use the Weller function to
reduce the temperature when the soldering equipment is
not in use.
• Coat the tip with solder prior to storage if you do not intend
to use the soldering iron for an extended period of time.
• Apply solder directly to the soldering area, not to the
soldering tip.
• Change the soldering tips using the designated tool.
• Do not apply mechanical force to the soldering tip.
Notice
The control units have been adapted to hold a
medium-sized soldering tip. Discrepancies may occur if
the tip is changed or a different shaped tip is used.
Error messages and error clearance
Message/symptom Possible cause Remedial measures
• Display: „- - - • Tool has not been detected
• Tool defective
• Tool not compatible
• Check connection of tool to device
• Check connected tool
• No display function (display
OFF)
• No mains supply voltage • Turn on mains power switch
• Check mains supply voltage
• Check device fuse
• OFF • Station is on standby or in OFF mode • Reactive the soldering tool using the UP
or DOWN buttons
• Tool remains cold • Station is on standby or in OFF mode • Move the gun
• Reactive the soldering tool using the UP
or DOWN buttons
• Temperature shown in the
display
• Tool remains cold
• Heating defective • Check/replace the soldering tool
• Station is not operating as it
usually does
• Parameters set incorrectly • Reset the station to the factory settings
• Settings cannot be changed • Station locked • Unlocking the station
• Zero Smog is not running • No mains supply voltage
• No signal detected
• Check the mains power supply
• Check the interface wiring
• Check the interface settings
GB
ENGLISH