User's Manual

NEOBIT 1014VA ADSL Router User’s Guide Chapter14
3. Select one of the predefined interface names from the EOA
Interface drop down list.
4. From the IPF Type drop-down list, select the level of IP
Firewall to be used on this interface, as defined above.
5. In the Lower Interface field, select the lower-level interface
name over which this protocol is being configured. Typically,
an EOA interface is configured to operate over an aal5
interface, such as aal5-0.
If you are using the NEOBIT 1014VA as a bridge only, skip to
step 7.
6. If you are using the NEOBIT 1014VA as a router on your
LAN, enter the IP address and network mask you want to
assign to the interface. This address serves as the public IP
address for your entire LAN and is usually assigned by your
ISP.
Or, if your ISP will assign this information, click the Enable radio
button to set up the DHCP service.
Also, specify whether this interface should serve as the default
route for your LAN for accessing the Internet.
7. Click
.
A confirmation page display to confirm your changes.
8. Click to return to the EOA page and view the new
interface in the table.
9. Click the Admin tab, and then click Commit & Reboot in the
task bar.
10. Click
to save your changes to permanent
memory.