User's Manual

Chapter20 NEOBIT 1014VA ADSL Router User’s Guide
Using Diagnostics
The diagnostics feature executes a series of test of your system
software and hardware connections. Use this feature when working
with your ISP to troubleshoot problems.
Follow these instructions to begin the diagnostics program:
1. Log into Configuration Manager, click the Admin tab, and
then click Diagnostics in the task bar.
Figure 70 shows the Diagnostics page.
Figure 70. Diagnostics Page
2. From the Virtual Circuits drop-down list, select the name of
your ATM interface (see Configuring the ATM VCC for a
explanation of ATM interfaces). Usually, this will be atm-0.
3. Click
.
The diagnostics utility will run a series of test to check whether the
device's connections are up and working. This takes only a few
seconds. The program reports whether the test passed or failed, as
shown in Figure 71. A test may be skipped if the program
determines that no suitable interface is configured on which to run
the test.