User's Manual

Chapter10 NEOBIT 1014VA ADSL Router User’s Guide
Adding IP Routes
Follow these instructions to add an IP route to the routing table.
1. From the IP Route Table page, click
.
The IP Route – Add page displays, as shown in Figure 40.
Figure 40. IP Route – Add Page
2. Specify the destination, network mask, and gateway or next
hop for this route.
For a description of these fields, refer to the table on page 87.
To create a route that defines the default gateway for your LAN,
enter 0.0.0.0 in both the Destination and Net Mask fields. Enter
your ISP’s IP address in the Gateway/NextHop field.
Note that you cannot specify the interface name, route type or
route origin. These parameters are used only for routes that are
identified automatically as the device communicates with other
routing devices. For routes you create, the routing table
displays system default values in these fields.
3. Click
.
4. On the confirmation page, click
to return to the IP
Route table page.
The IP Routing Table will now display the new route.
5. Click the Admin tab, and then click
Commit & Reboot in the
task bar.
6. Click
to save your changes to permanent
memory.