User's Manual

>ip relay all
>ip route add default 0.0.0.0 202.1.136.1 0:0:0:0
(Sets up default routing table between LAN subnet and WAN subnet)
> ip nat rfc1483 (this activates rfc1483 at net interface)
> config save
Saving configuration...Configuration saved.
> restart
After completing setup, connect the modem to HUB and PC to HUB, to use several PCs
for ADSL service at the same time. In this case, RJ-45 UTP Ethernet cable must be
straight cable, not cross cable.
Select "Obtain an IP address automatically" in "IP Address" tab of the "TCP/IP
Properties" on PC connected a HUB.
And give no gateway IP address at gateway tab.
Using Webconsole, you can change the protocol of the modem to RFC1483 Routed
mode by clicking on “Config/rfc1483 Routed”
In the mode of RFC1483 Routed, the
modem has two subnet for LAN and
WAN, each.
LAN IP address and Netmask take a
role as a gateway for LAN and
construct Private Subnet in case of
using NAT.
For setting as RFC1483 Routed, you
need to have the information for
VPI(Virtual Path Identifier)/VCI(Virtual Channel Identifier) from ISP.
The range of VPI value is from 0 to 4095,
and the range of VCI value is from 1 to 65535.
As well, you need to select a proper Data Encapsulation Method.
In case that the modem acts as a DHCP client and IP of WAN is assigned from CO
automatically, make DHCP enable. On the other hand, if IP is assigned from an ISP,
fill the blank of WAN IP Address and WAN Gateway.
If you want to set up LAN as a Private Subnet, make the NAT enable.