Specifications

SERVICING INSTRUCTIONS (continued)

TEMPERATURE ADJUSTMENT

Check temperature at discharge of faucet.

Remove thermostat access button plug to access thermostat.

Turn thermostat shaft clockwise to increase temperature.

REMOVE TANK LID ASSEMBLY

Unplug dispenser or turn circuit breaker OFF. Turn OFF water

supply. Remove rear panel.

Disconnect ll tube and vent tube from tank lid. Disconnect

wiring from hi-limit, thermostat and heating element as necessary.

Remove eight lid screws Remove lid assembly by lifting it

straight up.

Reassemble in reverse order.

REPLACE THERMOSTAT

Unplug dispenser. Remove back panel.

Loosen and free jam nut from pass-thru tting securing

thermobulb. Lift out probe, jamb nut and gasket. Disconnect

wiring from thermostat. Loosen screws holding thermostat to

bracket. Remove thermostat.

Reassemble in reverse order.

IMPORTANT:

The thermostat will maintain

temperature within ±3ºF.

For high altitude locations,

thermostat should be adjusted

to a maximum temperature

equal to the local boiling

temperature minus 5º. This

will prevent boiling water in the

dispenser,

NOTE:

Thermostat is adjustable to a

maximum of 199ºF.

IMPORTANT:

Water pressure must be

between 20 p.s.i and 90 p.s.i.

owing pressure. If water

pressure exceeds this value, or

if water pressure varies greatly,

a pressure regulator must be

installed in the water supply line.

IMPORTANT:

Before setting lid assembly into

tank, make sure tank lid gasket

is properly seated on ange of

lid.

712 p/n 2M-76580 1222_1225_1226 Owmers Manual