SINGLE HEAD and DUAL HEAD COUNTERTOP FRYERS with SAFETY TEST SYSTEM INSTALLATION USE & CARE F-55 STS, F-101, F-1725, F-85

ManualsBrandsWells ManualsFryerF-101

WELLS MANUFACTURING COMPANY

2 ERIK CIRCLE, P. O. Box 280

Verdi, NV 89439

Customer Service (775) 345-0444 Ext.502

fax: (775) 345-0569

www.wellsbloomfield.com

IMPORTANT: DO NOT DISCARD THIS MANUAL

This manual is considered to be part of the appliance and is to be given to the OWNER or

MANAGER of the restaurant, or to the person responsible for TRAINING OPERATORS of

this appliance. Additional manuals are available from your WELLS DEALER.

THIS MANUAL MUST BE READ AND UNDERSTOOD BY ALL PERSONS USING OR

INSTALLING THIS APPLIANCE. Contact your WELLS DEALER if you have any

questions concerning installation, operation or maintenance of this equipment.

OPERATION MANUAL

MODEL

F-55 STS

F-101

F-1725

SINGLE HEAD

and

F-85

DUAL HEAD

COUNTERTOP

FRYERS

with

SAFETY TEST

SYSTEM™

Includes

INSTALLATION

USE & CARE

302

p/n 304356 Rev. A M302 020102 cps

Model F-85

Model F-1725

Summary of content (14 pages)

PAGE 1
WELLS MANUFACTURING COMPANY 2 ERIK CIRCLE, P. O. Box 280 Verdi, NV 89439 Customer Service (775) 345-0444 Ext.502 fax: (775) 345-0569 www.wellsbloomfield.
PAGE 2
LIMITED WARRANTY STATEMENT Unless otherwise specified, all commercial cooking equipment manufactured by WELLS MFG. CO. is warranted against defects in materials and workmanship for a period of one year from the date of original installation or 18 months from the date of shipment from our factory, whichever comes first, and is for the benefit of the original purchaser only.
PAGE 3
TABLE OF CONTENTS WARRANTY SPECIFICATIONS FEATURES & OPERATING CONTROLS PRECAUTIONS & GENERAL INFORMATION AGENCY LISTING INFORMATION INSTALLATION OPERATION CLEANING INSTRUCTIONS MAINTENANCE TROUBLESHOOTING SUGGESTIONS PARTS & SERVICE CUSTOMER SERVICE DATA xi 1 2 3 4 4 6 7 8 8 9 9 INTRODUCTION Thank You for purchasing this Wells Manufacturing Co. appliance.
PAGE 4
FEATURES & OPERATING CONTROLS Fig.
PAGE 5
PRECAUTIONS AND GENERAL INFORMATION DANGER: BURN HAZARD Contact with hot oil will cause severe burns. Always wear protective clothing and heat resistant gloves when operating the fryer or filtering the oil. WARNING: ELECTRIC SHOCK HAZARD All servicing requiring access to non-insulated components must be performed by qualified service personnel. DO NOT open any access panel that requires the use of tools. Failure to heed this warning may result in severe electric shock.
PAGE 6
AGENCY LISTING INFORMATION This appliance conforms to NSF Standard 4 for sanitation only if installed in accordance with the supplied Installation Instructions and maintained according to the instructions in this manual. This appliance is 240V. STD 4 U Listed under UL File E6070 for 120V, 208V and E6070 INSTALLATION UNPACKING & INSPECTION Carefully remove the appliance from the carton.
PAGE 7
INSTALLATION (continued) WARNING: Electric Shock hazard All servicing requiring access to non-insulated electrical components must be performed by a factory authorized technician. DO NOT open any access panel which requires the use of tools. Failure to follow this warning can result in severe electrical shock. IMPORTANT: Refer to the General Layout Data packed with the fryer for wire size requirements and other installation data.
PAGE 8
OPERATION DANGER: BURN HAZARD Contact with hot oil will cause severe burns. Always wear protective clothing and heat resistant gloves when operating the fryer. CAUTION: NORMAL OPERATION Hot Surface 1. a. Be sure the TEMPERATURE CONTROL KNOB is turned to OFF. b. Lower the ELEMENT HEAD into the frypot by pushing back on the BASKET SUPPORT ROD, raising the ELEMENT HEAD SUPPORT ROD, then carefully lowering the elements. Exposed surfaces can be hot to the touch and may cause burns. 2.
PAGE 9
OPERATION—SAFETY TEST SYSTEM™ DANGER: BURN HAZARD Contact with hot oil will cause severe burns. Allow the fryer to cool before cleaning. Always wear protective clothing and heat resistant gloves when performing this test. 1. Fill the frypot to the MIN OIL line. Fresh oil is recommended to minimize smoking. 2. Clip the TEST THERMOMETER to a FRYER BASKET. Lower the fryer basket into the oil. Be sure the dial of the test thermometer can be clearly viewed.
PAGE 10
CLEANING INSTRUCTIONS DANGER: BURN HAZARD Contact with hot oil will cause severe burns. Allow the fryer to cool before cleaning. Always wear protective clothing and heat resistant gloves when cleaning the fryer. CAUTION: Electric Shock Hazard Disconnect fryer from electric power before cleaning.
PAGE 11
DISPOSAL OF USED OIL DANGER: BURN HAZARD Contact with hot oil will cause severe burns. Allow the fryer to cool before cleaning. Always wear protective clothing and heat resistant gloves when handling hot oil. PREPARATION Turn temperature control to OFF Allow fryer to cool completely before draining FREQUENCY Daily, or as needed TOOLS Container for disposal of used oil. OIL DISPOSAL 1. Turn temperature control to OFF. 2. Allow the oil to cool to a safe temperature (120ºF or 50ºC). 3.
PAGE 12
TROUBLESHOOTING SUGGESTIONS DESCRIPTION Fryer will not heat POSSIBLE PROBLEM SUGGESTED REMEDY Not plugged in or circuit breaker tripped Plug into proper receptacle Reset circuit breaker Temperature control knob not set to desired temperature Set to desired temperature Hi-limit safety tripped Clean element1, reset hi-limit Damaged internal component Contact Wells Authorized Service Agency for repairs Temperature control thermostat thermobulb contaminated with cooking debris Clean element2 Damage
PAGE 13
PARTS & SERVICE DESCRIPTION PART NO.
PAGE 14