Specifications

IMPORTANT: Programming changes to be performed by qualified persons only.

TRANSFER MENUS FROM MENU CARD TO CONTROLLER

Loading new settings to Controller from Menu Card to Oven using Smart Card Reader

NOTE: Oven must be in turned ON. No cooling timer or bake cycle can be active.

ACTION DISPLAY WILL READ

1. Insert menu card into card reader slot

Insert menu card with chip facing down.

Push in until resistance is met, then another 1/8” TESTING CARD (approx. 30 sec.)

PASSWORD 0000

2. Refer to page 22 for password READ MENU CARD NO

3. Press #2 button. READ MENU CARD YES

4. Press PROG button. TESTING CARD (approx. 30 sec.)

READING CARD

A rotating bar indicates the controller is

reading and downloading the information from

the menu card. When finished, audible alarm

will sound.

5. Remove card from slot and return to protective packaging.

6. Press START button. TOO COOL

TRANSFERRING MENUS FROM CONTROLLER TO MENU CARD

Saving new menu settings from Oven to Menu Card using Smart Card Reader

NOTE: Oven must be in turned ON. No cooling timer or bake cycle can be active.

ACTION DISPLAY WILL READ

1. Insert menu card into card reader slot

Insert menu card with chip facing down.

Push in until resistance is met, then another 1/8” TESTING CARD (approx. 30 sec.)

PASSWORD 0000

2. Enter password # 9793 READ MENU CARD NO

3. Press PROG button. WRITE MENU CARD NO

4. Press # 2 button. WRITE MENU CARD YES

5. Press PROG button. WRITING CARD

A rotating bar indicates the controller is

writing the information from the oven to

the menu card, and the information is being

accepted. When finished, audible alarm

will sound.

6. Remove card from slot and return to protective packaging.

7. Press START button. TOO COOL

PROGRAMMING INSTRUCTIONS (continued)

M903 2M-307323 Owners Manual M4200/M4200EU