Specifications

PREVENTATIVE MAINTENANCE (continued)

CAUTION:

BURN HAZARD

Allow appliance to cool

completely before adjusting.

Hinge Adjustment

HINGE ADJUSTMENT

PRECAUTIONS: None

FREQUENCY: As Needed

TOOLS: Phillips (+) Screwdriver

7/16" Nut Driver

7/8" and 1-1/8" Wrenches

THE FOLLOWING PROCEDURE IS TO BE

PERFORMED BY QUALIFIED PERSONNEL ONLY

1. Remove bottom panel to access pivot.

2. Gap between top of door and frame , and between bottom

of door and frame must be approximately equal

Adjust height of door by loosening jamb nut, then turning

pivot on its screw mounting. Clockwise lowers the door

height. Counter-clockwise raises the door height.

Re-tighten jamb nut.

3. Gap between left side of door and frame must be the

same from top to bottom

Adjust door for plumb by loosening holding screws. Turn

adjusting bolt to increase or decrease gap at bottom.

Clockwise increases gap. Counter-clockwise decreases gap.

Re-tighten holding screws.

4. Gap between top of door and frame must be the same

from side to side

Adjust door for level by loosening holding screws, then

raising or lowering latch-end of door until it is level.

Re-tighten holding screws.

5. Reinstall bottom panel.

Procedure is complete

M903 2M-307323 Owners Manual M4200/M4200EU