Owner`s manual

16
page 2 of 2
PM 903.3
PREVENTATIVE MAINTENANCE CARD
HINGE ADJUSTMENT
CONVECTION OVEN M4200
3. The door should be approximately centered between the upper and lower lips of the cabinet.
Adjust the door for height:
a. The hinge sleeve acts as a jam nut for the height adjuster.
b. The top and bottom clearances should be approximately equal. If necessary, loosen the
hinge sleeve and turn the height adjustment nut until the required clearances are
achieved.
c. Retighten the hinge sleeve.
4. Check fore-and-aft adjustment in two places on the hinge-side of the door. Use a piece of
paper (such as a dollar bill) between the inner surface of the door and the door gasket. The
paper should be definitely held, but should be able to be pulled out with just a slight drag.
5. To adjust a top or bottom hinge:
a. Loosen the holding bolts.
b. Tighten or loosen the adjusting bolt as needed to achieve the proper vertical clearance(s).
c. Retighten the holding bolts.
d. Recheck the clearances. Recheck the tightness of the bolts.
6. Reassemble the oven top, prep top and bottom trim panel. Remember to retighten the
screws for the lower gasket.
PROCEDURE IS COMPLETE
DO NOT REMOVE FROM MANUAL - PHOTOCOPY FOR DISTRIBUTION
HINGE BRACKET
HOLDING
BOLTS
DOOR PIVOT
ADJUSTING
BOLT
HINGE BRACKET
HOLDING
BOLTS
ADJUSTING
BOLT
HEIGHT
ADJUSTMENT
HINGE SLEEVE
WELLS MANUFACTURING COMPAN
Y
2 ERIK CIRCLE, P. O. Box 280
Verdi, NV 89439
Customer Service [phone] Ext.502
fax: [phone]
www.wellsbloomfield.co
m